0 of 30 Questions completed
Questions:
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading…
You must sign in or sign up to start the quiz.
You must first complete the following:
0 of 30 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
When utilizing the boxing system of measurement, the “B” measurements represents the________________.
A patient is found to have a monocular PD measuring R: 34mm and L: 32mm. The box measurement of the frame selected equals 56/20. Locate the major reference points (MRPs) for each eye.
Which of the following best describes a semi-rimless mounting?
When the measurements of patient’s PD and the GCDs are identical, the frame should be adjusted with:
One possible method of relieving a sore nose caused by the back edge of the nose pads is to:
A frame contains 10 degrees of pantoscopic angle. Ideally, the gaze will be directed approximately_________________above the optical center of the lens.
Pantoscopic angle may be increased by:
The geometrical center distance of a frame measuring 52/16 is:
A frame measures 50/18 and has an effective diameter of 52 mm. If the patient’s PD measures 59 mm, the theoretical minimum blank size required is:
If the right temple is angled out, this will cause:
The frame selection criteria most suitable for use with higher plus prescription lenses is:
“Bowing” the temples is a term used to describe__________________________.
When determining the actual minimum blank size, which of the following does not need to be considered?
While doing a frame adjustment, you notice the bottom of the eyewires are touching the cheeks. To remedy this situation you will:
When the measurement of the patient’s PD is less than the GCD’s of the frame, it is best to adjust the frame with:
The front of the frame may be raised by_____________________________.
________________angle exists when the bottom of the eyewire is inclined outward, farther away from the face than the top.
In order to decrease the distance between the nose pads of a frame it is necessary to bend the pad arms:
The term DBL designates the___________________.
The frame size is 54/20 and the patient’s PD measures 66 mm. In this case:
What would be the “theoretical” minimum blank size for the following frame and PD combination?
Box measurements: A=52mm; DBL=16mm; ED=53mm; PD=58 mm
Angling the pad arms farther apart will result in:
The “B” measurement of a frame is equal to 56mm on the box. A FT 35 bifocal segment is fit at a height of 21mm.
Where is the segment line positioned relative to the datum line of the frame?
A frame with a saddle bridge has been selected for a child of seven years. For which of the following reasons is this a better choice than a comparable frame with adjustable pads?
If the patient’s left ear is higher than the right, and the frame is in standard alignment, it can be expected that the frame will fit:
A frame with pantoscopic tilt is fit so that:
Your patient has selected a frame with the following dimensions: A=56 mm; B=52 mm; DBL= 22 mm
If the segment line is dropped 6 mm below the datum line, what is the seg height?
The boxing system of measurement can accurately locate the____________ of the lens.